Mateksys r24 vario ELRS receiver channel 5 only 1 pin #2603
Unanswered
Capt-737NG
asked this question in
Q&A
Replies: 2 comments
-
If you have a spare PWM connector use that an drive the landing gear with the respective mixer channel. It now: your receiver should have a single pin marked 8. Use that to connect to the landing gear servo signal pin. Get + and - from one of the reveivers servo connector. The landing gear should now be controllable by EdgeTX mixer 8. |
Beta Was this translation helpful? Give feedback.
0 replies
-
Thanks a lot Michael, I’ll do that! Cheers
Cristiano
…On Wed, 27 Mar 2024 at 06:40 Michael ***@***.***> wrote:
If you have a spare PWM connector use that an drive the landing gear with
the respective mixer channel.
It now: your receiver should have a single pin marked 8. Use that to
connect to the landing gear servo signal pin. Get + and - from one of the
reveivers servo connector. The landing gear should now be controllable by
EdgeTX mixer 8.
—
Reply to this email directly, view it on GitHub
<#2603 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ATTDTRZE2XL63CWDIMFQ72LY2IPQXAVCNFSM6AAAAABEZ6JV6OVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DSMRSGU4TQ>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Dear members, I want to use the channel 5 to control the landing gear (retract/extend) but there’s only one pin, while the LG servo has 3 pins (+ - S) which pin should I connect to the channel 5 on the receiver?
Beta Was this translation helpful? Give feedback.
All reactions