Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Firmware recovery for XL-320 using OpenCM 9.04 #328

Open
MarioSotoF opened this issue Jun 19, 2023 · 1 comment
Open

Firmware recovery for XL-320 using OpenCM 9.04 #328

MarioSotoF opened this issue Jun 19, 2023 · 1 comment

Comments

@MarioSotoF
Copy link

Hi, I have 4 XL-320 motors but the led on them is not blinking when powering up them, I tried using R+ Manager to do a firmware recovery on them but at the moment of turning off and on the Dynamixel the program shows me an error that says that the installation failed. This error occurs with the 4 Dynamixel. Im using an opencm 9.04 to do all this. Any suggestions? Is there a solution?
@shiba-8ro
Copy link

shiba-8ro commented Jun 20, 2023 •
edited

@MarioSotoF
This is a checklist just in case.

  1. Does OpenCM904 perform Firmware recovery by R+Manager?
  2. Are the XL-320 and OpenCM904 connected one-to-one?
  3. The working voltage of XL-320 is 7.4V. You can't use it with 12V.
  4. If you have U2D2, better use it. In that case, using Dynamixel Wizard2.0 is recommended over R+Manager.

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
2 participants
@shiba-8ro @MarioSotoF