You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
First of all, Ttank you for the great project!
I'm going through this tutorials and I found a trivial mistake in the middle of it.
In the lesson3 of getting-started, I added an actuator on a virtual device and wrote the code as the text said.
Then, I realized the last screenshot showed 300 as max value.
This must be greater than 300. Otherwise the LED never turns off.
Looking closer at the line 15 of the picture, I can see "If light < 2". So, I guess this worked well when it was taken.
This is a trivial issue, but I suggest fixing it to avoid any confusion.
The text was updated successfully, but these errors were encountered:
First of all, Ttank you for the great project!
I'm going through this tutorials and I found a trivial mistake in the middle of it.
In the lesson3 of getting-started, I added an actuator on a virtual device and wrote the code as the text said.
Then, I realized the last screenshot showed 300 as max value.
This must be greater than 300. Otherwise the LED never turns off.
Looking closer at the line 15 of the picture, I can see "If light < 2". So, I guess this worked well when it was taken.
This is a trivial issue, but I suggest fixing it to avoid any confusion.
The text was updated successfully, but these errors were encountered: