This example shows how to use the common/http_client API. Note that HTTP operation is NOT supported on the LENA-R8 cellular module.
To build and run this example on a supported platform you need to travel down into the port/platform/<platform>/mcu/<mcu> directory of your choice and find the runner build. The instructions there will tell you how to set/override #defines. The following #defines are relevant:
U_CFG_APP_FILTER: set this to exampleHttpClient (noting that NO quotation marks should be included) to run just this example, as opposed to all the examples and unit tests.
For the remainder of the #defines you may either override their values in the same way or, if you are only running this example, you may edit the values directly in http_main.c before compiling.
U_CFG_TEST_CELL_MODULE_TYPE: consult u_cell_module_type.h to determine the type name for the cellular module you intend to use. For instance, to use SARA-R5 you would set U_CFG_TEST_CELL_MODULE_TYPE to CELL_CFG_MODULE_SARA_R5.
U_CFG_APP_PIN_CELL_xxx: the default values for the MCU pins connecting your cellular module to your MCU are #defined in the file port/platform/<platform>/mcu/<mcu>/cfg/cfg_app_platform_specific.h. You should check if these are correct for your board and, if not, override the values of the #defines (where -1 means "not connected").
U_CFG_APP_CELL_UART: this sets the internal HW UART block that your chosen MCU will use to talk to the cellular module. The default is usually acceptable but if you wish to change it then consult the file port/platform/<platform>/mcu/<mcu>/cfg/cfg_hw_platform_specific.h for other options.
Obviously you will need a SIM in your board, an antenna connected and you may need to know the APN associated with the SIM (though accepting the network default often works).
U_CFG_TEST_SHORT_RANGE_MODULE_TYPE: consult u_short_range_module_type.h to determine the type name for the short range module you intend to use.
For instance, to use NINA-W15 you would set U_CFG_TEST_SHORT_RANGE_MODULE_TYPE to U_SHORT_RANGE_MODULE_TYPE_NINA_W15`.
U_CFG_APP_SHORT_RANGE_UART: this sets the internal HW UART block that your chosen MCU will use to talk to the short range module. If you wish to change the default value refer to the file u_cfg_app_platform_specific.h under your chosen port/platform.
Make sure antenna is connected on to the board and you should be connected to wifi access point for http_client to work.