Skip to content

Latest commit

 

History

History
75 lines (54 loc) · 1.75 KB

Readme.md

File metadata and controls

75 lines (54 loc) · 1.75 KB

Go NFC library example code

This is an example code for reading a NFC/RFID tag with a reader using NFC library for Go. The NFC library requires to have libnfc 1.8.0+ installed on your device.

I was using a Raspberry Pi with PN532 and followed the instructions from Adafruit: Building libnfc on Raspberry Pi .

Building libnfc for PN532

  1. Get and extract the libnfc:

     cd ~
     mkdir libnfc && cd libnfc/
     wget https://github.com/nfc-tools/libnfc/releases/download/libnfc-1.8.0/libnfc-1.8.0.tar.bz2
     tar -xvjf libnfc-1.8.0.tar.bz2

    Next two steps depend on your reader and it's configuration of libnfc

  2. Create PN532 configuration:

     cd libnfc-1.8.0
     sudo mkdir /etc/nfc
     sudo mkdir /etc/nfc/devices.d
     sudo cp contrib/libnfc/pn532_uart_on_rpi.conf.sample /etc/nfc/devices.d/pn532_uart_on_rpi.conf 
     sudo nano /etc/nfc/devices.d/pn532_uart_on_rpi.conf
  3. Update the pn532_uart_on_rpi.conf:

    allow_intrusive_scan = true
    
  4. Install dependencies for building:

     sudo apt-get install autoconf
     sudo apt-get install libtool
     sudo apt-get install libpcsclite-dev libusb-dev
     autoreconf -vis
     ./configure --with-drivers=pn532_uart --sysconfdir=/etc --prefix=/usr
  5. Build the library:

    sudo make clean
    sudo make install all

Running the code:

Clone the repo:

git clone https://github.com/xBlaz3kx/nfc-reader-go-example/

Install the libnfc, then run:

go run nfc-reader-example.go 

or

 go build nfc-reader-example.go && ./nfc-reader-example