Skip to content

Read LTO tape RFID cartridge memory (LTO-CM / MAM) with libnfc

Notifications You must be signed in to change notification settings

philpem/nfc-ltocm

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

24 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

LTO Cartridge Memory (LTO-CM / MAM) reader for libnfc

Author: Phil Pemberton philpem@philpem.me.uk

Usage

  • Place an LTO tape on your NFC reader, with the CM chip (on the label side, opposite the write-protect tab) centred over the aerial.
  • Run nfc-ltocm.
  • Feed the output to LTO-CM-Analyzer
  • Enjoy.

Hints on antenna/LTO placement

The ACR122U (Touchatag) reader can read LTO-CM chips quite reliably, if slowly. Place the LTO-CM chip over the centre of the Touchatag (or NFC) logo.

The SCL3711 also works, but antenna placement is more critical. Place the tape flat down, with the rear-right corner over the NFC reader's antenna. Support the front-left corner to stop the tape from slipping.

The LTO-CM chip is located at the back of the cartridge, behind the right side of the label. This is on the opposite side of the label from the write protect tab.

Limitations

To reduce the potential for abuse by unscrupulous dealers of "refurbished" media, nfc-ltocm can only read from the LTO-CM chip. Write support is not present, nor is it likely to be added.

LTO-CM memories of type 3 are not supported, due to a lack of tapes to test with.

LTO-CM memories of type 4 or later are not supported, as these are not specified in ECMA-319. If you have a datasheet or specification for a later revision of LTO-CM memory chip, please contact me on the email address above. If you've successfully added Type 3 or later memory device support, please open a PR.

Credits

This code is based on the libnfc-mfsetuid example included with libnfc.

LTO-CM is specified in Annexes D and F of ECMA-319

Licence

This is the same licence as applies to the libnfc examples.

Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met:

  1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.

  2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

About

Read LTO tape RFID cartridge memory (LTO-CM / MAM) with libnfc

Topics

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published