You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is there any chance someone knows how to send a “S0” to the reader via the Arduino/Red Board?
If you use the URA, you can set it up in the options on the right. I believe that if there is a way to do this in continuous read mode it will minimize reading the same tags too often.
The text was updated successfully, but these errors were encountered:
I believe we mention in the hookup guide, that while we try to provided as much functionality as possible, there is no way to reproduce all the functionality of the URA without a lot of reverse engineering. Therefore, I am labeling this issue as wontfix, but I will leave it open for the time being. (*However, if there is no further progress, we will eventually close the issue.)
Is there any chance someone knows how to send a “S0” to the reader via the Arduino/Red Board?
If you use the URA, you can set it up in the options on the right. I believe that if there is a way to do this in continuous read mode it will minimize reading the same tags too often.
The text was updated successfully, but these errors were encountered: